The P2475: Exhaust Gas Temperature Sensor Circuit Low Bank 2 Sensor 4 refers to an issue where low voltage is detected in the exhaust gas temperature sensor circuit for Bank 2 Sensor 4. This may be caused by a faulty sensor, wiring issues, or connector problems, potentially leading to inaccurate temperature readings, which can affect exhaust management, engine performance, and emissions control.
P2475 – Quick Overview
| Code | Information |
|---|---|
| Meaning | P2475: Exhaust Gas Temperature Sensor Circuit Low Bank 2 Sensor 4 |
| Is it serious? | Yes, this code can lead to inaccurate exhaust temperature readings, which may result in improper engine performance and higher emissions. |
| Possible causes | – Low voltage in the exhaust gas temperature sensor circuit for Bank 2 Sensor 4 – Faulty sensor – Wiring or connector issues |
| How to diagnose? | – Measure voltage in the exhaust gas temperature sensor circuit for Bank 2 Sensor 4 – Inspect and test the sensor and wiring – Replace faulty components if needed |
P2475 Meaning
The P2475: Exhaust Gas Temperature Sensor Circuit Low Bank 2 Sensor 4 code indicates that the exhaust gas temperature sensor for Bank 2 Sensor 4 is experiencing lower than expected voltage levels. This could be due to a sensor malfunction, faulty wiring, or a connector problem, which can lead to improper readings of exhaust gas temperatures, affecting engine efficiency and emissions.
Step-by-step diagnostic guide
| Action | Description | Tools Needed |
|---|---|---|
| Check for Other Codes | Use an OBD-II scanner to determine if there are other related codes present. Other codes could provide additional clues regarding the issue. | OBD-II Scanner |
| Inspect Sensor and Wiring Visually | Visually inspect the exhaust gas temperature sensor for signs of physical damage. Inspect the wiring and connectors leading to Bank 2 Sensor 4 for loose, damaged, or corroded parts. | Flashlight, Safety Gloves |
| Measure Voltage in the Sensor Circuit | Use a multimeter to measure the voltage at the exhaust gas temperature sensor for Bank 2 Sensor 4. Compare the measured values with manufacturer specifications to determine if they are below the expected range. | Multimeter, Manufacturer’s Specifications |
| Check Wiring Continuity | Use a multimeter to verify the continuity of the wiring. Check for any shorts, breaks, or other issues that could cause low voltage readings. Move the harness while testing to check for intermittent faults. | Multimeter |
| Inspect and Test Connectors | Check all connectors for secure fitment, corrosion, or other issues that might cause an electrical fault. Clean or replace connectors as needed to ensure proper circuit performance. | Contact Cleaner, Replacement Connectors |
| Replace Faulty Sensor | If the sensor is determined to be faulty, replace it with a new, manufacturer-approved component. Ensure the installation is secure and follows manufacturer guidelines. | Replacement Sensor, Basic Hand Tools |
| Clear Code and Test Drive | Clear the P2475 code using an OBD-II scanner, and take the vehicle for a test drive. Monitor the exhaust gas temperature readings to confirm proper sensor performance. | OBD-II Scanner, Vehicle Owner’s Manual |
| Recheck for Codes | After the test drive, use the OBD-II scanner to ensure that the P2475 code has been cleared and no new codes have appeared. If the code returns, further investigation will be required. | OBD-II Scanner |
Popular OBD2 guides
See all guides
Best OBD2 scanners in 2025
I constantly test new OBD-II scanners to give you the best options possible. Here is a full list of the best tools in all categories currently.
